Search results

(1 - 2 of 2)
Performance Analysis of Energy Harvesting- Non-Orthogonal Multiple Access IoT Network
Title
Performance Analysis of Energy Harvesting- Non-Orthogonal Multiple Access IoT Network
Creator
Ni, Zhou
Date
2019
Description
Internet of Things (IoT) systems in general consist of a lot of devices with massive connectivity. Those devices are usually constrained with...
Show moreInternet of Things (IoT) systems in general consist of a lot of devices with massive connectivity. Those devices are usually constrained with limited energy supply and can only operate at low power and low rate. One solution to limited energy is to use energy harvesting to provide sustainable energy. The set of technologies adopted in next-generation wireless communication systems, such as massive MIMO and Non-Orthogonal Multiple Access (NOMA), can provide solutions to increase the throughput of IoT systems. In this thesis, we investigate a cellular-based IoT system combined with energy harvesting and NOMA. We consider all base stations (BS) and IoT devices follow the Poisson Point Process (PPP) distribution in a given area. The unit time slot is divided into two phases, energy harvesting phase in downlink (DL) and data transmission phase in uplink (UL). That is, IoT devices will first harvest energy from all BS transmissions and then use the harvested energy to do the NOMA information transmission. We define an energy harvesting circle within which all IoT devices can harvest enough energy for NOMA transmission. The design objective is to maximize the total throughput in UL within the circle by varying the duration T of energy harvesting phase. In our work, we also consider the inter-cell interference in the throughput calculation. The analysis of Probability Mass Function (PMF) for IoT devices in the energy harvesting circle is also compared with simulation results. It is shown that the BS density needs to be carefully set so that the IoT devices in the energy harvesting circle receive relatively smaller interference and energy circles overlap only with small probability. Our simulations show that there exists an optimal T to achieve the maximum throughput. When the BSs are densely deployed consequently the total throughput will decrease because of the interference.
Show less
PREPARATION OF MG3SB2-XBIX THERMOELECTRIC MATERIAL AND THEIR LASER SINTERING BEHAVIOR
Title
PREPARATION OF MG3SB2-XBIX THERMOELECTRIC MATERIAL AND THEIR LASER SINTERING BEHAVIOR
Creator
Xiao, Xudong
Date
2020
Description
In the introduction part, a novel thermoelectric material, Zintl compounds were introduced due to its potential high thermoelectric...
Show moreIn the introduction part, a novel thermoelectric material, Zintl compounds were introduced due to its potential high thermoelectric performance in low-temperature applications as thermoelectric devices. Recent researches focused on Mg3Sb2-based Zintl Compounds was summarized in this article, and the general methods and its limitations to fabricate Mg3Sb2-based thermoelectric modules were introduced. Thus, a novel selective laser melting process was introduced, and it has enormous potential to fabricate Mg3Sb2-based thermoelectric modules in commercial applications. What’s more, the challenges of selective laser melting method were also discussed in the articles. For developing selective laser melting as the mature method to fabricate Mg3Sb2-based thermoelectric modules, many works and researches need to be done. In my project, the powder of Mg3.1(Sb0.3Bi0.7)1.99Te0.01 thermoelectric material was synthesized by using the mechanical alloying process and the proper particle size and distribution of powder using for selective laser melting was obtained by increasing the time of mechanical alloying. The thermoelectric properties of the powder prepared by mechanical alloying were measured, and it shows the powder still in a good performance after a long-time mechanical alloying particle reduction process. Finally, the obtained powder was treated by different parameters of continued wave fiber laser. The morphology and composition of the sintered area were analyzed to better understanding the process of laser sintering. More work needs to be done for using a selective laser melting method to fabricate Mg3Sb2-based thermoelectric modules in the future.
Show less